CartVisualCreate account

When should I clone a Flair custom product model instead of keeping the base model and changing the prompt?

Flair’s documented route for changed training images is to clone the existing custom model and train a separate version. For a colorway that keeps the same construction, Flair recommends one base model with color specified in the prompt. Confirm which change the campaign needs before collecting new training images or generating from a selected model.

Published · By CartVisual editorial team

Separate a new trained product version from a prompted variant

Look at the differences the buyer must see. A replacement pump shape or a new lid is a construction change. Flair says direct retraining of an existing model is unavailable. Clone that model and begin a new training run with the revised images. Keep the original associated with the earlier product.

For the same construction in a different color, Flair recommends keeping one base model and prompting the color. Compare the result against the authorized color reference before using it. If the buyer needs an exact swatch and the result drifts, use a verified photograph or a controlled recolor instead of approving a close match.

Prepare the new training state without inventing mode equivalence

Flair specifies six to ten consistent, high-quality reference images for training. Preserve a set that represents the same physical revision. Reject inputs that mix the predecessor’s parts with the replacement’s parts.

The setup instructions use Standard and Fast, while the FAQ comparison uses Standard and Instant (Beta). Choose the available labeled mode and check its behavior for that account. The source does not establish that Fast and Instant are aliases. Standard is described as the higher-accuracy option and takes about three hours.

Select the intended model before judging the generated product

When the updated model becomes available, select it in the generation workflow. If a result still shows the predecessor's construction, first confirm which trained model was selected. If the selection is correct, compare the part against the approved reference to decide whether the asset can be used.

Hypothetical decision: a dispenser with a revised pump

Bottle B1 has a short pump head. B2 has an angled pump, and the seller has eight authorized photos showing it. Clone B1, train with the B2 references, and select the resulting model for B2 creative work. Keep B1 available for any remaining B1 inventory.

A navy B1 with the same pump calls for a different first step: prompt the base model for the approved navy and compare the returned image with the navy reference. If the output changes the pump, hold it. The prompt solved only the intended color request.

Source and evidence scope

Prepared by the CartVisual editorial team with AI assistance. Competitor behavior is documented rather than independently executed for this guide.

Flair: Flair FAQ and workflow controls

Official source snapshot checked .

Flair's supplied FAQ supports cloning instead of direct retraining, a six-to-ten-image input, color-variant prompting advice, and Standard versus faster-mode descriptions. The FAQ uses both Fast and Instant terminology without explaining equivalence. No training, generation, or quality comparison was performed.

Related decisions

Browse ecommerce creative workflows